IBM BladeCenter HT 8740, Руководство по диагностике и обслуживанию

Страница: 81 / 158

5. Pull the release handle or handles to the open position. The interposer moves
out of the bay approximately 0.6 cm (0.25 inch).
6. If you are instructed to return the interposer, follow all packaging instructions
and use any packaging materials for shipping that are supplied to you.
Installing an I/O-module interposer
To install an I/O-module interposer or interposer tray, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 31.
2. Make sure that the I/O-module interposer release handle or handles are in the
open position.
3. Slide the interposer into the module bay until it stops.
4. Push the release handle or handles to the closed position.
5. Install an I/O module or filler (see “Installing an I/O module” on page 65).
Chapter 4. Removing and replacing BladeCenter HT components
63