IBM 8853L6U, Руководство по обслуживанию

Страница: 63 / 146

Installing a microprocessor and heat sink
To install a microprocessor and heat sink, complete the following steps.
Heat sink
Microprocessor 2
Microprocessor 1
and heat sink
Microprocessor
heat sink filler
Attention: Do not touch the contacts in the microprocessor socket. Touching
these contacts might result in permanent damage to the system board.
1. Install the microprocessor:
Attention: Do not use any tools or sharp objects to lift the locking lever on the
microprocessor socket. Doing so might result in permanent damage to the
system board.
Microprocessor
release lever
Microprocessor
retainer
a. Rotate the locking lever on the microprocessor socket from its closed and
locked position until it stops in the fully open position (approximately a 135°
angle), as shown.
b. Rotate the microprocessor retainer on the microprocessor socket from its
closed position until it stops in the fully open position (approximately a 135°
angle), as shown.
c. Touch the static-protective package that contains the microprocessor to any
unpainted metal surface on the BladeCenter unit or any unpainted metal
surface on any other grounded rack component; then, remove the
microprocessor from the package.
d. Remove the cover from the bottom of the microprocessor.
Microprocessor
Microprocessor
socket
Alignment marks
Microprocessor retainer
e. Center the microprocessor over the microprocessor socket. Align the triangle
on the corner of the microprocessor with the triangle on the corner of the
socket and carefully place the microprocessor into the socket.
Chapter 4. Removing and replacing blade server components
47