IBM 8853L6U, Руководство по обслуживанию

Страница: 46 / 146

Installing a SAS hard disk drive
To install a SAS hard disk drive, complete the following steps.
SAS ID 0
SAS ID 1
Hard disk drive
release lever
Hard disk
drive release
lever
1. Identify the location (SAS ID 0 or SAS ID 1) in which the hard disk drive will be
installed.
Note: If you will be installing the SAS hard disk drive in to the SAS ID 1
location, you may need to remove a standard-form-factor expansion card tray
(see “Removing a standard-form-factor expansion card” on page 38); then,
install the SAS hard disk drive tray with the four screws you removed from the
expansion card tray.
2. Touch the static-protective package that contains the hard disk drive to any
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the hard disk drive from
the package.
Attention: Do not press on the top of the drive. Pressing the top might
damage the drive.
3. Place the drive into the hard disk drive tray and push it toward the rear of the
drive, into the connector until the drive moves past the lever at the front of the
tray.
4. Install the Memory and I/O Expansion Blade, if one was removed from the blade
server in order to remove a SAS hard disk drive (see “Installing an expansion
unit” on page 27).
5. Install the blade server cover (see “Installing the blade server cover” on page 25
for instructions).
6. Install the blade server into the BladeCenter unit (see “Installing the blade
server in a BladeCenter unit” on page 22 for instructions).
30
BladeCenter HS21 Types 1885 and 8853: Problem Determination and Service Guide