IBM 86803RU - Netfinity 7000 M10, Руководство по техническому обслуживанию аппаратной части, Страница: 21 / 278

Notes
1. To run the diagnostic programs, you must start
the server with the highest level password.
That is, if you enter the power-on password and
an administrator password is set, you cannot run
the programs. You can only view the error
messages in the Test Log.
You must enter the administrator password to run
the diagnostic programs.
2. If the server stops during testing and you cannot
continue, restart the server and try running the
diagnostic programs again. If the system hangs
while running memory tests, press the reset
button 3 times waiting five seconds between
each reset. This procedure tells BIOS to disable
memory performance enhancements for a more
accurate memory test. Press F2 to select
diagnostics. An 062 error will occur on the third
reset; exit Setup and the diagnostics will load.
Run the memory test again.
3. If the diagnostic tests do not find a problem but
the problem persists during normal operations, go
to “Undetermined Problems” on page 205.
4. You might have to install a wrap connector on
your active parallel or serial port to obtain
accurate test results for these ports. If you do
not have a wrap connector, contact your IBM
reseller or IBM marketing representative.
5. You might need a scratch diskette to obtain
accurate test results when testing the diskette
drive.
6. The keyboard and mouse (pointing device) tests
assume that a keyboard and mouse are attached
to the server.
To start the diagnostic programs:
1. Turn on the server and watch the screen.
If the server is turned on already, shut down your
operating system and restart the server.
2. When the message
F2 for Diagnostics
appears,
press F2.
If a power-on password or administrator password is
set, the server prompts you for it. Type in the
appropriate password; then, press Enter.
The Diagnostic Programs screen appears.
3. Select either Extended or Basic from the top of the
screen.
4. Select the test you want to run from the list that
appears; then, follow the instructions on the screen.
Netfinity 7000-M10 - Type 8680
13