IBM 86803RU - Netfinity 7000 M10, Руководство по техническому обслуживанию аппаратной части

Страница: 189 / 278

Note
Avoid touching the components and gold-edge
connectors on the adapter.
6. Place the adapter, component-side up, on a flat,
static-protective surface.
7. Set any jumpers or switches as described by the
adapter manufacturer.
8. Install the adapter:
a. Carefully grasp the adapter
.7/
by its top edge
or upper corners, and align it with the expansion
slot on the I/O board.
b. Press the adapter firmly into the expansion slot.
Attention
When you install an adapter in the server,
be sure that it is completely and correctly
seated in the connector before you apply
power. Incomplete insertion might cause
damage to server components or the
adapter.
c. Refer to the illustration in “Installing a Hot-Plug
PCI Adapter” on page 176 for operation of the
adapter retention latch on the end of the slot
near the rear of the server.
d. Lower the tab over the adapter. Rotate the
adapter retention latch until it snaps in place.
e. Connect any cables to the adapter.
9. If you have other options to install or remove, do so
now; otherwise, go to “Completing the Installation” on
page 97.
Verifying Compatibility between Network
Adapters and Device Drivers:
Your server
supports several types of network adapters. If you are
having trouble with the installation or operation of a
network adapter or network operating system, ensure that
the network-adapter device driver supports multiple
processors. Refer to your network-adapter documentation
for additional information about adapter compatibility
requirements.
Netfinity 7000-M10 - Type 8680
181