IBM 86803RU - Netfinity 7000 M10, Руководство по техническому обслуживанию аппаратной части, Страница: 103 / 278

2. If you removed the I/O function card, install it:
a. Refer to the illustration in step 2a on page 93
while you perform the steps in this procedure.
b. Carefully grasp the I/O function card by its top
edge, and insert the tabs
.3/
on the bottom
edge of the metal connector plate into the
matching openings on the server back panel.
c. Align the I/O function card with the guide on the
opposite end of the adapter and the slot on the
I/O board.
d. Press the I/O function card firmly into the slot.
Attention: When you install the I/O function
card in the server, be sure that it is completely
and correctly seated. Incomplete insertion might
cause damage to server components.
e. Insert the two screws you removed in step 2c on
page 93.
f. Connect the cables you disconnected in step 2b
on page 93.
3. Reinstall the server top cover or front access cover
and connect the cables (see “Completing the
Installation” on page 97).
Three-Pin Jumper Blocks:
With the three-pin jumper
blocks, each jumper covers two of the three pins on a pin
block. You can position the jumper to fit over the center
pin and either of the other two pins.
The following illustration identifies pins 1, 2, and 3 on a
three-pin jumper block:
2 1 3
To change the jumper position on a three-pin jumper
block:
1. Lift the jumper straight off the pin block.
2. Align the holes in the bottom of the jumper with the
center pin and the pin that was not covered
previously.
Netfinity 7000-M10 - Type 8680
95