IBM 8671 - Eserver xSeries 235, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 103 / 222

a. From the rear of the server, remove the two screws at each side of the
fixed power supply.
b. Gently pull the power supply from the server, making sure the cables do
not snag on the chassis or system board.
Note: You might need to insert a fingernail or screwdriver blade behind
one corner of the power supply to begin moving it.
CAUTION:
When installing the power supply, do not pull it into position by its
cables.
6. Install the hot-swap power-supply option.
Note: The option consists of a hot-swap power-supply cage containing two
hot-swap power supplies, with all necessary cables attached to the back
of the option.
2 1
Cables
Hot-swap power
supply option
a. Push the cables on the back of the power-supply option into the
power-supply bay first; then, slide the hot-swap power-supply cage with
power supplies into the power-supply bay.
b. From inside the server, pull the cables on the back of the power-supply
cage up from under the system board.
c. Secure the hot-swap power-supply cage to the server by installing the two
screws at each side of the hot-swap power-supply cage.
7. Connect the power-supply cables to the system board and devices in your
server.
Note: Each connector on these cables is unique. Only one type of cable can
be attached to each connector on the system board, backplanes, or
devices.
a. Connect the small-device power cable (P7) to the back of the diskette
drive.
Chapter 4. Customer replaceable units
93