IBM 8671 - Eserver xSeries 235, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 52 / 222

Table 5. Ethernet troubleshooting chart
Ethernet controller
problem
FRU/actions
The server stops
running when loading
device drivers.
The PCI BIOS interrupt settings are incorrect.
Check the following:
v
Determine if the interrupt (IRQ) setting assigned to the Ethernet controller is also
assigned to another device in the Configuration/Setup Utility program.
Although interrupt sharing is allowed for PCI devices, some devices do not function well
when they share an interrupt with a dissimilar PCI device. Try changing the IRQ
assigned to the Ethernet controller or the other device. For example, for NetWare
Versions 3 and 4, it is recommended that disk controllers not share interrupts with LAN
controllers.
v
Make sure that you are using the most recent device driver available from the World
Wide Web.
v
Run the network diagnostic program.
v
Reseat or replace the adapter.
Ethernet link status LED
does not work.
Check the following:
v Make sure that the hub is turned on.
v
Check all connections at the Ethernet controller and the hub.
v Use another port on the hub.
v
If the hub does not support auto-negotiation, manually configure the Ethernet controller
to match the hub.
v
If you manually configured the Duplex mode, make sure that you also manually
configure the speed.
v
Run diagnostics on the LEDs.
v Reseat or replace the adapter.
The Ethernet
transmit/receive activity
LED does not work.
Check the following:
v
Make sure that you have loaded the network device drivers.
v
The network might be idle. Try sending data from this server.
v Run diagnostics on the LEDs.
Data is incorrect or
sporadic.
Check the following:
v
Make sure that you are using Category 5 or higher cabling when operating the server at
100 Mbps or at 1000 Mbps.
v
Make sure that the cables do not run close to noise-inducing sources like fluorescent
lights.
The Ethernet controller
stopped working when
another adapter was
added to the server.
Check the following:
v
Make sure that the cable is connected to the Ethernet controller.
v Make sure that your PCI system BIOS code is current.
v
Reseat the adapter.
v
Determine if the interrupt (IRQ) setting assigned to the Ethernet adapter is also assigned
to another device in the system. Use the Configuration/Setup Utility program to
determine if this is the case.
Although interrupt sharing is allowed for PCI devices, some devices do not function well
when they share an interrupt with a dissimilar PCI device. Try changing the IRQ
assigned to the Ethernet adapter or the other device.
v Reseat or replace the adapter.
The Ethernet controller
stopped working without
apparent cause.
Check the following:
v
Run diagnostics for the Ethernet controller.
v Try a different connector on the hub.
v
Reinstall the device drivers. See your operating-system documentation and the
ServerGuide information.
v
Reseat or replace the adapter.
42
xSeries 235 Type 8671: Hardware Maintenance Manual and Troubleshooting Guide