IBM 8671 - Eserver xSeries 235, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 131 / 222

c. Fit the left tab (in the rack configuration, this is the top tab) into the lip on
the chassis, and then press on the right tab (in the rack configuration, this
is the bottom tab) until it snaps into place.
Diskette drive
Complete the following steps to remove the diskette drive.
Note:
v Read “Installation guidelines” on page 45.
v
Read the safety notices at “Safety information” on page 169.
v Read “Handling electrostatic discharge-sensitive devices” on page 172.
1. Turn off the server and all attached devices.
2. Disconnect all external cables and power cords from the back of the server.
3. Remove the server cover (see “Removing the left-side cover” on page 55).
4. Remove the front bezel (see “Removing the bezel” on page 56).
5. Press in on the two blue diskette drive release tabs until the drive is released
from the chassis.
6. Carefully pull the drive away from the chassis until the cables at the rear of the
drive are accessible.
7. Remove the two cables from the back of the drive and pull the drive out.
8. To replace the diskette drive, reverse the previous steps.
Note: If you are replacing the drive, prepare the new drive for the server with
the following procedure:
a. Remove the side rails from the drive by gently pulling them away
from the drive until they detach.
b. Insert one pin of the rail into the notch near the rear of the drive.
c. Pushing the rail gently toward the rear of the drive, insert the other
pin into the notch near the front of the drive.
d. Press in on the metal strip in the rail to secure the rail to the drive.
Chapter 5. Service replaceable units
121