IBM 8671 - Eserver xSeries 235, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 101 / 222

1 2
I/O cable-restraint
bracket
Power-cord
restraint bracket
Hot-swap
power supply 2
Hot-swap
power supply 1
AC power LED
DC power LED
Handle
Release latch
Before you continue with the power-supply removal and installation procedure,
review the following information.
Notes:
1. During normal operation, both hot-swap power-supply bays must have power
supplies installed for redundancy.
2. Two cable-restraint brackets are on the rear of the tower model servers. After
you install the hot-swap power-supply option and connect the cables to the
selected devices, you can use these cable-restraint brackets to manage the
cable routing. Route the power cords through the power-cord restraint bracket
on the bottom. Route the remaining cables (for example, the cables that are
connected to the I/O ports) through the I/O cable-restraint bracket on the top.
If you install or remove a power supply, observe the following precautions.
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following label
attached.
Hazardous voltage, current, and energy levels are present inside any component that
has this label attached. There are no serviceable parts inside these components. If
you suspect a problem with one of these parts, contact a service technician.
Complete the following steps to remove the fixed power supply and install the
hot-swap power-supply option.
Chapter 4. Customer replaceable units
91