IBM 8671 - Eserver xSeries 235, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 31 / 222

Table 2. Power-on and administrator password features (continued)
Type of password Features
Administrator and
power-on password
v
You can type either password to complete the system startup.
v The administrator password provides access to all choices on
the Configuration/Setup Utility main menu. You can set,
change, or delete both the administrator and power-on
passwords and allow a power-on password to be changed by
the user.
v
The power-on password provides access to a limited set of
choices on the Configuration/Setup Utility main menu. This
limited access might include changing or deleting the power-on
password.
Using the LSI Logic Configuration Utility program
LSI Logic Configuration is a built-in, menu-driven configuration utility program that
you can use to:
v
Perform a low-level format of a SCSI hard disk drive
v Set a SCSI device scan order
v
Set a SCSI ID for a controller
Notes:
1. The integrated SCSI controller with RAID capabilities in your server supports
only RAID level-1. Installing an optional ServeRAID-5i controller provides
additional RAID levels. However, if a ServeRAID-5i controller is installed and
later removed, you must re-enable the on-board SCSI controller in using the
Configuration/Setup Utility program (see “Starting the Configuration/Setup Utility
program” on page 15). See “Using ServeRAID Manager” on page 25 for
information on configuring your server for RAID operation.
2. If you install a different type of RAID adapter in your server, use the
configuration method supplied with the RAID adapter to view or change SCSI
settings for attached devices.
The following sections provide the instructions needed to start the LSI Logic
Configuration Utility program and to format a SCSI hard disk drive.
Starting the LSI Logic Configuration Utility program
Complete the following steps to start the LSI Logic Configuration Utility program:
1. Turn on the server.
2. When the
<<< Press <CTRL><C> to start LSI Logic Configuration Utility
>>>
prompt appears, press Ctrl+C.
Note: If an administrator password has been set, you are prompted to type the
password to start the LSI Logic Configuration Utility program.
3. Use the arrow keys to select a controller (channel) from the list of adapters;
then, press Enter.
4. Follow the instructions on the resulting screen to change the settings of the
selected items; then, press Enter. The Device Properties and Mirroring
Properties choices produce additional screens of parameters to review or
change.
Chapter 2. Configuration
21