IBM 8671 - Eserver xSeries 235, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 76 / 222

Adapter guide
b. Carefully grasp the adapter by its top edge or upper corners, and align it
with the expansion slot on the system board.
Attention: When you install an adapter in the server, be sure that it is
completely and correctly seated in the system-board connector. Incomplete
insertion might cause damage to the system board or the adapter.
c. Press the adapter firmly into the expansion slot.
Note: If the server is subject to excessive movement or vibration, you can
secure the adapter with a screw: insert one of the backup
expansion-slot screws (stored next to slot 1) through the top of the
adapter bracket into the screw hole to secure the adapter before
proceeding to the next step.
d. Lower the adapter-retention latch over the top corner of the adapter. In slot
5 or 6, make sure the latch is in the locked (closed) position.
11. If you installed a full-length adapter, close the adapter-retention clip on the
adapter-support bracket. Otherwise, continue with the next step.
12. Connect any needed cables to the adapter.
Attention: When you route the cables, do not block the ventilated space
around any of the fans.
13. If you have other options to install or remove, do so now; otherwise, go to
“Installing the server bezel and left-side cover (tower model)” on page 100 or
“Installing the server bezel and top cover (rack configuration)” on page 103.
Cabling example for a ServeRAID controller
You can install an optional IBM ServeRAID controller in your server to control the
internal hot-swap hard disk drives. A ServeRAID controller can, for example, enable
you to configure the internal hot-swap hard disk drives into disk arrays. The
illustrations in this section show the cabling for internal hot-swap hard disk drives.
You can also cable a ServeRAID adapter to external hard disk drives. See your
ServeRAID controller option documentation for complete instructions for installing a
ServeRAID controller in your server and for additional information about ServeRAID
controllers.
66
xSeries 235 Type 8671: Hardware Maintenance Manual and Troubleshooting Guide