IBM 8671 - Eserver xSeries 235, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 159 / 222

Note: See “System” on page 162 to determine which components should be replaced by a field service technician.
Error code/symptom FRU/action
289
(DIMM disabled by POST or user)
1. Run the Configuration/Setup Utility program, if the DIMM was
disabled by the user.
2. Disabled DIMM, if not disabled by user.
301
(Keyboard or keyboard controller error)
1. Keyboard
2. System board
303
(Keyboard controller error)
v
System board
602
(Invalid diskette boot record)
1. Diskette
2. Diskette drive
3. Cable
4. System board
604
(Diskette drive error)
1. Run the Configuration/Setup Utility program and diagnostics.
2. Diskette drive.
3. Drive cable.
4. System board.
605
(Unlock failure)
1. Diskette drive
2. Drive cable
3. System board
662
(Diskette drive configuration error)
1. Run the Configuration/Setup Utility program and diagnostics.
2. Diskette drive.
3. Drive cable.
4. System board.
762
(Coprocessor configuration error)
1. Run the Configuration/Setup Utility program.
2. Battery.
3. Microprocessor.
962
(Parallel port error)
1. Disconnect the external cable on the parallel port.
2. Run the Configuration/Setup Utility program.
3. System board.
11XX
(System board serial port 1 or 2 error)
1. Disconnect the external cable on the serial port.
2. Run the Configuration/Setup Utility program.
3. System board.
1301
(I
2
C cable to front panel not found)
1. Verify operator information panel cable is connected to J24 on
system board.
2. Cable.
3. Front panel
4. Power switch assembly
5. System board
1302
(I
2
C cable from system board to power on
and reset switches not found)
1. Verify power on and reset switch cable is connected to J23 on
system board.
2. Cable.
3. Power switch assembly
4. System board
Chapter 6. Symptom-to-FRU index
149