IBM 8285 Nways, Инструкция по установке и эксплуатации

Страница: 144 / 265

SNMP Using “LAN Emulation Over ATM”
To manage the workgroup switch from an “LAN Emulation Over ATM” subnetwork, perform the following
steps:
1
Set the IP address, subnetwork mask and LEC parameters, as described in “LAN Emulation
Client (LE only)” on page 117, using the command:
set device lan_emulation_client
2
Set the default gateway, as described in “Default Gateway (IP & LE)” on page 117, using the
command:
set device default_gateway
3
Set the community table, as described in “Community Table (IP & LE)” on page 118, using
the command:
set community
4
Specify which alerts you want to enable, as described in “Alerts (IP & LE)” on page 118,
using the command:
set alert
5
Return to “Procedure 2: Configuring the ATM Workgroup Switch” on page 24.
Notes:
1. You may select only one of the subnetworks to be used for the Default Gateway.
2. Although it is expensive, nothing prevents you from using both subnetworks at the same time, each
subnetwork being independent from the other (no communication between them). In the latter case
an ARP server and an 802.3/Ethernet V2 LES are required. Only one of the subnetworks may be
chosen for the Default Gateway.
116
IBM 8285 Nways ATM Workgroup Switch: Installation and User’s Guide