IBM 8285 Nways, Инструкция по установке и эксплуатации

Страница: 114 / 265

Setting Passwords
It is necessary to set two levels of workgroup switch passwords:
Ÿ Administrator password that provides access to all ATM Workgroup Switch commands with
read-write (configuration) access
Ÿ User password that provides access to a subset of ATM Workgroup Switch commands including
most SHOW commands, PING and TELNET.
See the
IBM 8285/8260: ATM Command Reference Guide for more information on access to ATM
Workgroup Switch commands.
Administrator Password
1. At the console prompt, type the SET DEVICE PASSWORD ADMINISTRATOR command:
à
@
ð
8285
>
set device password administrator
Then press Enter.
2. In the next three fields displayed, enter your current password and the new password (up to fifteen
characters) twice as shown below. For security purposes, the values you enter are not displayed on
the screen.
à
@
ð
Enter current administrator password: {old password}
New password:
{new password}
Re-enter password: {new password}
Then press Enter. You are prompted when your password is accepted:
à
@
ð
Password changed.
3. To save your new password, type the SAVE DEVICE or the SAVE ALL command:
à
@
ð
8285
>
save device
Then press Enter.
You will need to enter the new administrator password the next time you log on to the workgroup switch.
Note that you have only ten seconds to enter a password when the Password prompt is displayed. If you
do not enter a password, a Timeout message is displayed. To redisplay the Password prompt and start
again, press Enter.
86
IBM 8285 Nways ATM Workgroup Switch: Installation and User’s Guide