IBM 7133 D40, Руководство по обслуживанию

Страница: 290 / 306

6. The hdisk connection location number [connwhere] is displayed (for example,
0004AC5119E000D). Make a note of this number; you will need it later in this
procedure.
7. Remove the new hdisk number by giving the command:
rmdev -l [hdisknumber] -d
where
[hdisknumber]
is the hdisk number that you want to remove (for example,
hdisk12).
8. Remove the definition of the original hdisk by giving the command:
rmdev -l [hdisknumber] -d
where
[hdisknumber]
is the hdisk number of the original disk drive module (for
example, hdisk7).
9. Give the command:
mkdev -p ssar -t hdisk -c disk -s ssar -w [connwhere] -l [hdisknumber]
where
[connwhere]
is the connection location number that you noted in step 6, and
[hdisknumber]
is the hdisk number you want for the new disk drive module (for
example, hdisk7).
10. If you want to remove, from the system configuration, pdisk numbers that are not
used, give the following command for pdisks that remain defined:
rmdev -l [pdisk] -d
where
[pdisk]
is the number of the pdisk that you want to remove from the
configuration.
Configuring a 7133 to the Using System
Use the cfgmgr command to configure or reconfigure a 7133 Model D40 or Model T40
to the using system.
Unconfiguring a 7133 from the Using System
To remove a 7133 Model D40 or Model T40 from the using system, give the following
command:
rmdev -l [enclosurenumber] -d
where
[enclosurenumber]
is the enclosure device that was generated by the cfgmgr
command (for example,
[enclosure0]
,
[enclosure1]
,
[enclosure2]
).
272
7133 Models D40 and T40 Service Guide