IBM 6000 VA LCD 4U, Руководство по установке и обслуживанию

Страница: 10 / 88

CAUTION:
v Do not install a unit in a rack where the internal rack ambient temperatures
will exceed the manufacturer’s recommended ambient temperature for all
your rack-mounted devices.
v
Do not install a unit in a rack where the air flow is compromised. Ensure
that air flow is not blocked or reduced on any side, front, or back of a unit
used for air flow through the unit.
v
Consideration should be given to the connection of the equipment to the
supply circuit so that overloading of the circuits does not compromise the
supply wiring or overcurrent protection. To provide the correct power
connection to a rack, refer to the rating labels located on the equipment in
the rack to determine the total power requirement of the supply circuit.
v (For sliding drawers) Do not pull out or install any drawer or feature if the
rack stabilizer brackets are not attached to the rack. Do not pull out more
than one drawer at a time. The rack might become unstable if you pull out
more than one drawer at a time.
v
(For fixed drawers) This drawer is a fixed drawer and must not be moved
for servicing unless specified by the manufacturer. Attempting to move the
drawer partially or completely out of the rack might cause the rack to
become unstable or cause the drawer to fall out of the rack.
(R001 part 2 of 2)
Important:
1. To reduce the risk of fire, connect only to a circuit provided with branch circuit
overcurrent protection with an ampere rating in accordance with the National
Electrical Code (NEC), ANSI/NFPA 70 or your local electrical code.
UPS output power 200 V 208 V 230 V
6000 VA 40 amp, 2-pole circuit
breaker 40 amp, 2-pole circuit
breaker 32 amp (Europe), 40
amp (North America),
2-pole circuit breaker
2. For permanently connected equipment: Make sure that a readily accessible
disconnect device is incorporated in the building installation wiring.
3. You can connect only one extended battery module to the UPS.
4. For input voltage rating 115/200 – 127/220 V ac, the IBM 6000 VA LCD 4U
Rack UPS (200 V / 208 V) must be connected phase-to-phase (and not
phase-to-neutral), so that the input voltage of the UPS is 200 V or 220 V.
viii
6000 VA UPS and 6000 VA EBM: Installation and Maintenance Guide