FEATURES OF YOUR HYUNDAI
1- 82
6.Adjust Treble
Press
button and then multifunction button
(2) "-" or "+". TREB and the set value are dis-
played. Set the desired treble via both buttons.
Center setting: Press both buttons simulta-
neously.
7. Adjust Balance
Press
button and then multifunction button (3)
" " or " ". BAL and the set value are displayed.
Set the desired balance via both buttons.
Center setting: Press both buttons simulta-
neously.
8. Fader
Press
button and then multifunction button (4)
" " or " ". FAD and the set value are displayed.
Set the desired fade level via both buttons.
Center setting: Press both buttons simulta-
neously.
9. Loudness On / Off
Press
button and then multifunction button (5)
"LD". LOUD ON or LOUD OFF are displayed.
The loudness can be switched on or off alter-
nately by pressing the multifunction button.
10.Linear Adjustment
It controls the amplification ratio from high to low
tone. Activate tone menu. Then again press and
hold button
for more than 2 seconds. The
tone values for the set signal source (e.g. radio/
FM) are set to an average value FM LINEAR.
Press and hold
button for more than 4 sec-
onds. All tone values for the signal sources radio
and tape /CD are set to an average value ALL
LINEAR.
11.Adjust Mono /Stereo
Three different reception optimization setting can
be set in order to suppress reception dependent
interference and reflections.
Repeatedly press multifunction button (6) "ST" in
tone menu until the desired optimization is set.
AUTO: Setting for normal operation - i.e., the unit
switches from stereo to mono and back depend-
ing upon reception location (provides the opti-
mum setting for almost all reception areas).
STEREO: Setting for unusual reception situa-
tions - i.e. the unit is set permanently to stereo
(e.g. for private radio stations in city areas)
MONO: Setting for reception conditions in which
reflections constantly occur - i.e., the unit is set
constantly to mono.
The setting is effective immediately after press-
ing the multifunction button "ST" and is also
retained on switching off.
B260D01GK-GAT
RADIO OPERATION
1. Select operating Mode
Press
Button. The operating mode. Radio,
CD can be selected.
The last selected operating mode is selected
after the button is pressed for the first time. If the
other operating modes are to be selected, press
the
button quickly and repeatedly until the
desired operating mode is selected.
2. Select Waveband
Press
button repeatedly until desired
waveband FM 1, FM 2 or AM is selected. When
changing the waveband, the last selected station
is selected.
3. Switch on radio menu mode
Press
button. The radio menu mode is
switched on and displayed, The unit switches
back to the normal display if no buttons are
pressed within the next 8 seconds.
4. Radio Operation
Setting procedures for station selection.
The desired broadcasting station can be se-
lected via station search, manual tuning,
autostore, direct frequency input and station
buttons.
