Hyster J30XNT, Руководство по эксплуатации

Страница: 195 / 226

How to Change the Batteries
General
WARNING
Batteries are heavy and can cause an injury. Use care
to avoid injury. A single trained operator should per-
form the battery exchange, while other personnel
remain clear. DO NOT put hands, arms, feet and or legs
between the battery and solid objects.
Make sure the capacity of the crane and spreader bar is
greater than the weight of the battery. The weight of the
battery is normally shown on the battery case. The
maximum battery weight is shown on the lift truck
Nameplate. The spreader bar must NOT be made of
metal or it must have insulated straps.
The replacement battery must fit the battery area cor-
rectly. Adjust the front spacer plate to prevent battery
movement in the battery compartment. Make sure that
the battery voltage and weight of the replacement bat-
tery is correct as shown on the Nameplate.
Before connecting the battery, make sure the key or
keyless switch is in the OFF position and the parking
brake is set.
CAUTION
Batteries must be discarded or recycled according to
local environmental regulations.
Remove the Battery
1. Use the tilt memory lever and tilt the steering column all
the way up. Make sure it is latched.
2. If lift truck is equipped with manual hydraulic control lev-
ers, release the latch for the control lever assembly and
move the assembly to the forward position. On lift trucks
equipped with E-Hydraulic control mini-levers, move the
armrest all the way back if necessary to raise the hood.
See
Table 1 .
3. Slide the seat all the way back. For lift trucks equipped
with Rapid/Fast Charging, slide the seat all the way for-
ward. Push the latch handle to the right to raise the hood
and seat to fully raised position.
Maintenance
193
Property of American Airlines