hymer BMC 550, Инструкция по эксплуатации

Страница: 59 / 252

Pitching the Motorcaravan 5
B-MC - 12/18-2 - EHG-0016-01EN
59

Press the "On/Off/Mode" button (Fig. 45,6) briefly. The mode changes
between Manual and Automatic. The corresponding LED (Fig. 45,1 or
Fig. 45,9) lights up.

Press any button.

Switch on ignition.

Apply the handbrake.

Press the "Extend" (Fig. 45,5) button. The alignment procedure is per-
formed automatically. The "Steady leg" LEDs (Fig. 45,8) flash as long as
the steady legs are moving.
If the vehicle has folding supports: Movement of the steady legs ceases
after unfolding to give you the chance to put chocks in place. The "Auto-
matic mode" LED (Fig. 45,9) flashes rapidly.

Press the "Extend" button (Fig. 45,5) again. The alignment procedure is
continued.

Switch on ignition.

Apply the handbrake.

Press the brake pedal.

Press the "Retract" button (Fig. 45,4). The steady legs retract com-
pletely. The "Steady leg" LEDs (Fig. 45,8) flash as long as the steady
legs are moving.

Press the "On/Off/Mode" button (Fig. 45,6) briefly in Automatic mode.
The "Manual mode" LED (Fig. 45,1) lights up.

Pay attention to the "Inclination" LEDs (Fig. 45,2). An illuminated LED
indicates that the vehicle must be raised on this side.

Press the "Next" button (Fig. 45,7) as often as necessary until the de-
sired pair of steady legs is selected. The corresponding "Steady leg"
LEDs (Fig. 45,8) light up.

Press the "Retract" (Fig. 45,4) or "Extend" button (Fig. 45,5) until the de-
sired position is reached.

Press the "Next" button (Fig. 45,7) again until another desired pair of
steady legs is selected. Repeat the procedure until the vehicle is
aligned. The vehicle is aligned when the green "Position ok" LED
(Fig. 45,3) lights up.

Ensure that all steady legs are in contact with the ground.
The OK position of the position sensor must be recalibrated following a
power failure (faulty fuse, battery disconnected).

Align the vehicle in Manual mode using a spirit level.

Press the "On/Off/Mode" (Fig. 45,6), "Extend" (Fig. 45,5) and "Retract"
(Fig. 45,4) buttons simultaneously and keep them pressed for 3 sec-
onds.

Release the buttons following audible acknowledgement and illumina-
tion of the "Position ok" LED (Fig. 45,3). The position is saved as the OK
position.

Retract the supports in Automatic mode. This causes the controller to
readjust itself.
Changing mode:
Stopping every movement:
Extending the steady legs
in Automatic mode:
Retracting the steady legs
in Automatic mode:
Manual mode:
Calibrating the position
sensor: