hymer BMC 550, Инструкция по эксплуатации

Страница: 196 / 252

11 Care
196
B-MC - 12/18-2 - EHG-0016-01EN

Fill water tank with water and some washing-up liquid (do not use any
scourers).

Using a trade standard brush for washing dishes, scrub the water tank
until there is no longer any visible deposit.

Scrub also the pump housing.

If possible, clean fresh water sensors through the cleaning openings by
hand.

Rinse water tank with copious amounts of drinking water.

If, due to the design of the water tank, it is not possible to clean the wa-
ter tank mechanically: Use a suitable chemical cleaning agent.
The authorised dealers would be happy to assist you in choosing a suit-
able cleaning agent.
Follow the cleaning agent manufacturer's instructions.
11.6.2 Cleaning the water pipes

Only use suitable cleaning agents as sold by the specialist trade.

The cleaning agent must meet national regulations and be approved (if
required).

Collect any emerging mixture of water and cleaning agent for correct dis-
posal.

Empty the water system.

Close all drainage openings and drain cocks.

Fill mixture of water and cleaning agent into the water tank.
Observe the manufacturer's instructions regarding the mixing ratio.

Open the drain cocks one by one.

Leave the drain cocks open until the mixture of water and cleaning
agent has reached the respective drain.

Close the drain cocks.

Set all the water taps to "Hot" and open them.

Leave the water taps open until the mixture of water and cleaning agent
has reached the drain.

Set all water taps to "Cold" and open them.

Leave the water taps open until the mixture of water and cleaning agent
has reached the drain.

Close all water taps.

Flush the toilet several times.

Allow the cleaning agent to act in accordance with the manufacturer's
instructions.

Empty the water system. Collect the mixture of water and cleaning agent
for correct disposal.

For rinsing fill the entire water system with drinking water and empty
again several times over.