hymer BMC 550, Инструкция по эксплуатации

Страница: 183 / 252

Sanitary fittings 10
B-MC - 12/18-2 - EHG-0016-01EN
183
10.5.3 Emptying the sewage tank

If the vehicle is equipped with an electrical ventilation system, the plug
connection on the sewage tank must be disconnected before emptying.

The sewage tank can only be taken out if the sliding trap is closed.

Take any further information from the manufacturer's instruction manual.
Fig. 202 Flap (sewage tank)

Slide the slide lever on the toilet bowl in a clockwise direction. The sli-
ding trap is closed.

Open the flap for the sewage tank on the outside of the vehicle. Insert
the key into the locking cylinder of the push-button lock (Fig. 202,1) and
turn a quarter turn in a clockwise direction.

Remove the key.

Press both push-button locks (Fig. 202,2) simultaneously with your
thumb and open the flap for the sewage tank.
Fig. 203 Sewage tank (in the vehicle) Fig. 204 Sewage tank

If the vehicle is equipped with an electrical ventilation system: Pull off
the hose of the ventilation system.

Pull the safety clamp (Fig. 203,3) upwards and use the handle
(Fig. 203,2) to pull out the sewage tank (Fig. 203,1).

At a disposal station that is especially provided for this purpose, swivel
the outlet pipe (Fig. 204,1) forwards and unscrew cover (Fig. 204,2).

Press the coloured ventilation button (Fig. 204,3) and hold it there until
the sewage tank is empty.

Clean the sewage tank with fresh water.

Close outlet pipe with cover and swivel it back.