hymer BMC 550, Инструкция по эксплуатации

Страница: 29 / 252

Before the journey 3
B-MC - 12/18-2 - EHG-0016-01EN
29

Use the supporting system offered by your dealer if two-wheelers are
transported in the rear garage.

Do not drill into the vehicle floor. Do not screw any screws into the vehi-
cle floor.
1 Clamping eyelet
2 Clamping rail
Fig. 3 Clamping eyelets (rear ga-
rage)

Turn the clamping eyelet (Fig. 3,1) half a turn in an anticlockwise direc-
tion. Now, the clamping eyelet (Fig. 4) may be moved.
Fig. 4 Clamping eyelet (movable) Fig. 5 Clamping eyelet (clamped)

Push the clamping eyelet into the clamping rail (Fig. 3,2) to the desired
position.

Give clamping eyelet one half turn in a clockwise direction. The clamp-
ing eyelet (Fig. 5) sits tightly in the clamping rail again.

Check that the clamping eyelet is tight.
3.2.6 Bike rack

Observe the permissible axle loads and maximum permissible gross
weight when loading the bike rack.

A total width of 2.55 m must not be exceeded. Adjust the attachments
for the bikes accordingly. The overhang to the side and rear must be
marked in accordance with the regulations for the country in which
you are travelling.
 Load the bike rack with bicycles only.

Do not transport more than the permitted number of bicycles for the
bike rack used (max. 50 kg).
Moving the clamping
eyelets: