16
Troubleshooting E1 Error Code
Error Code 1 indicates water temperature is below a set point after timeout during heating
phase of the cycle.
1.
Remove hot water inlet hose and check for hot water to Hydrim.
2.
Check inlet filter screen is clean on hot water valve.
3.
Turn OFF the cold water valve and start a P1 cycle. If the unit does not fill with water E2
appears, the hot water valve is defective.
4.
Start a P1 cycle, when you hear the wash arms start turning stop the cycle and check the
water temperature in the chamber with a thermometer. Suggested hot water temperature to
the unit is 60
°
C/140
°
F. If water is cold, cycle time will be extended until wash temperature
reaches 50
°
C/122
°
F. The heater will increase the water temperature approximately 2
°
C
every minute. If wash temperature is not reached in 25 minutes the cycle will timeout and
E1 will appear.
Hot Water Valve
Filter Screen
Содержание L110W
Страница 1: ...Hydrim L110W Training Manual Training Manual ...
Страница 4: ...4 ...