14
Hydrim L110W P3 & P4 Cycle with Revision 2.02 Software (Cond.)
25.
Circulation, heating and dosing
Start circulation pump M1, dosing pump M4 and turn ON water heater R1 if water
temperature in chamber is below target temperature. Start heating and dosing error timers.
Dosing pump runs for 5 seconds. If flow switch does not detect dosing before the dosing
error timer ends (30 seconds), the Hydrim fails with an
ED code
. Once selected dosing time
is achieved the dosing pump will turn OFF.
26.
Circulation and heating target temperature 65
°
C/149
°
F
Circulation pump continues to run and water heater remains turned ON. If the heating error
timer ends and the chamber water temperature is below the target temperature, the Hydrim
fails with an
E1 code
.
27.
Circulation 180 seconds/3 minutes
28.
Circulation and evacuation 10 seconds
29.
Evacuation 20 seconds
30.
Drying (P4 cycle only)
Dryer time factory set to 10 minutes. May be increased to 20 minutes in 1-minute
increments. Dryer will run at slower speed for 1 minute then increase to high speed.
Содержание L110W
Страница 1: ...Hydrim L110W Training Manual Training Manual ...
Страница 4: ...4 ...