Protocol
Control
System
Users
Manual
2/12/01
Figure 57- Suction Configuration Screen 7
This is the last configuration screen for the
suction group. The suction group can be named
by selecting the name field and using the UP or
DOWN ARROW keys to select a letter, then
pressing the ENTER key to move to the next
letter.
8.5.2.5 Discharge Pressure Configuration
This screen shows the configuration screen for
the discharge pressure setup. Note that the
only field on this screen is the setting of the
Alarm setpoint (in PSI).
Figure 58- Discharge Configuration Screen
8.5.2.6 Lighting Configuration
The following screens show the configuration
screens for lighting control.
Figure 59- Lighting Configuration Screen 1
Table 34- Lighting Configuration Screen 1
Field
Explanation
State
Read Only field that
displays whether the
circuit is ON or OFF
Output 1:
Displays the output point
(board/point) assignment
for the output relay.
Figure 60- Lighting Configuration Screen 2
Table 35- Lighting Configuration Screen 2
Field
Explanation
Type Control:
Displays the control mode
for the lighting circuit.
Can be either SCHED-
controlled from a schedule
or DIG- controller from a
digital input point (ON
when the input is high)
Figure 61- Lighting Configuration Screen 2A
Note that Figure 61 shows the screen in Figure
60 if the Type Control field is set to DIGITAL.
Field
Explanation
Type Control
Displays the control mode
for the lighting circuit.
Can be either SCHED-
controlled from a schedule
or DIG- controller from a
digital input point (ON
when the input is high)
Dig Input:
Displays the input point
(board/point) assignment
for the input.
Figure 62- Lighting Configuration Screen 3
Page 30
