Husqvarna CR 65 2012, Руководство по ремонту

Страница: 84 / 174

G.12
CR 65 2012
4
5
6
7
B
4
1
2
3
5
6
7
ENGINE OVERHAUL
Workshop Manual Ed. 09-2011
Kick start pedal shaft pre-assembly
– Fasten the shaft ( 4 ) of the kick start pedal with the lower grooved side in the
vice (use protection jaws).
– Insert the starting gear (
5
) with the stopping toothing down on the kick start
pedal shaft.
– Engage the kick start pedal spring ( 6 ) in the suitable hole of the kick start pedal
shaft and fit the driving hub ( 7 ) with opening A above the spring end part.
– Remove the kick start pedal shaft from the vice.
Gearbox shafts – component wear check
– Fasten the input and output shafts in the vice (use
protection jaws). Remove the gears and check for wear and seizure signs in
the following points:
– the supporting points of the input and output shafts, and of the neutral
gears;
– the gear front couplings;
– the teeth sides of all gears;
– the toothing profiles of the input and output shafts and of the relevant
gears;
– check the smoothness of the gearbox gear contours.
Thoroughly clean all parts and replace the faulty ones.
Upon each repairing of the gearbox first mount the new circlips.