Rivco GL18006-L2, Инструкция по установке

Страница: 1 / 5

#GL18006-L2
2001-2017
Honda Gold Wing 1800 & F6B models
Lower Cowl LED Driving Lights
INSTALLATION INSTRUCTIONS
1. Lay out and familiarize yourself with the parts included in the set. Remove the left fairing
storage compartment as follows: Open the lid, then on the left side notice there are four
plastic push pin rivets in the corners of the compartment housing. Using a Phillips
screwdriver, push the center pins in slightly until they “click” (about ¼”), then pull the entire
rivet assemblies out of the holes. Next - gently pull outward on the color matched trim strip
covering the outside edge of the compartment until it pops out at the top and center,
leaving the bottom still attached - then remove the compartment. Remove the Left color
matching frame or side cover and the cover to the front of it. Remove the plastic shield from
the battery’s positive terminal. Remove the lower fairing cowl as follows: Remove the six
5mm hex screws and two plastic push in pins from the cowl - then pull the bottom of the
cowl out first, and then down. Remove the left and right plastic “D” shaped covers (1A) held
in place by two 8mm hex bolts each (1B).
2. Notice the back of the lights with brackets are marked L and R. Place the four supplied
washers and lock washers onto the four supplied 10mm bolts. Referring to photo (2A) and
starting with the left light and bracket assembly, place the 50mm long (longer of the two)
bolts with washers through the bracket (2B), then two of the supplied plastic spacers on
each bolt (1C) and finally the “D” shaped cover removed earlier as shown. Then tighten the
bolts securely. Referring to photo (3) assemble the right side in the same manner using the
40mm long (remaining shorter bolts) with only one plastic spacer on each bolt and finally
through the “D” shaped cover, then tighten both bolts securely.
3. Locate the supplied wire harness. Attach the black ground wire from the harness with the
ring terminal to the engine using the 8mm bolt shown in photo (1C). Connect the shorter set
of black and red wires to the left lights black and red wires. Route the wire loom over to the
right light and connect the remaining black and red wires to it. Secure the wires and loom to
the others on the motorcycle using the supplied cable ties.
4. Route the remaining red wire up and inside the left fairing compartment removed earlier as
follows. Routing or “fishing” the wire is best done using a piece of stiff wire (a cut and
straightened piece of a wire coat hanger works well) with a small loop bent at one end then
pushed from desired point to point, placing the wire to be “fished” through the loop several
inches, and bent over firmly, then pulling the stiff wire back out.
5. Working inside the left fairing compartment and referring to photo (4), connect and secure
the supplied relay and switch assembly as follows: Plug the red wire from the lights onto
the remaining outer terminal on the relay (4B) (not the center terminal, this will not be
used). Locate the unused red two-pin wire connector on the motorcycle’s wire harness