Husqvarna CR 65 2012, Руководство по ремонту

Страница: 91 / 174

H.5
CR 65 2012
1
2
3
A
4
5
6
7
ENGINE REASSEMBLY
Workshop Manual Ed. 09-2011
Refitting the selector plate and the gearbox control shaft
– Place the selector spring ( 1 ) as shown in the engine casing picture.
– Fit the selector lever ( 2 ) with the roller faced to the casing and the circlip ( 3 )
with the sharp edge upwards.
– Engage the selector spring to the casing prong A.
– Push the selector lever back and fit the selector on its drum.
– Degrease the screw thread ( 4 ), smear the thread with Loxeal 24-18 and fasten
the selector plate to 14 Nm.
– Grease the gearbox control shaft oil seal.
– Grease the pre-assembled gearbox control shaft and carefully insert it in the
engine casing. Push the sliding plate back and insert the gearbox control
shaft fully inside the engine casing.
– Fit the gear shift pedal and insert, in sequence, all gears by contemporarily
turning the input shaft. Afterwards remove the gear shift pedal again.
Clutch reassembly
– Fit the idle gear ( 5 ) with the beat faced to the casing on the supporting pin.
– Insert the thrust washer ( 6 ) and the greased supporting bushing ( 7 ) onto the
input shaft.
– Insert the clutch housing and the thrust washer (17.2x30x1.5 mm) on the
input shaft.
– Fit the pre-assembled plate pack.
– Smear some Loxeal 86-54 in the screw thread and fit the screw with the Bel-
leville washer (see the assembly diagram at page G.10).
– Place the clutch retainer using the suitable wrench and tighten the screw to
50-52 Nm.