14
ELECTRICAL SYSTEM
85
14.7
Changing the headlight bulb
Note
Damage to reflector
Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
C00099-10
Main work
–
Turn protection cap
1
with the bulb socket beneath it all the way counterclockwise
and lift it off.
–
Pull bulb socket
2
of the parking light out of the reflector.
100463-10
–
Press headlight bulb
3
lightly into the bulb socket, turn it all the way counter-
clockwise, and pull it out.
–
Insert the new headlight bulb.
(TE EU/AUS)
Headlight (S2/socket BA20d) (
–
Insert the protection cap with the bulb socket into the reflector and turn it all the
way clockwise.
–
Insert the bulb socket of the parking light into the reflector.
Finishing work
–
Install the headlight mask with the headlight. (
14.8
Changing the turn signal bulb (TE EU/AUS)
Note
Damage to reflector
Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
101722-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove turn signal glass
1
.
–
Lightly squeeze orange cap
2
in the area of the holding lugs and take it off.
–
Press the turn signal bulb lightly into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W/socket BA15s) (
–
Mount the orange cap.
–
Position the turn signal glass.
–
Insert the screw and first turn it counterclockwise until it engages in the thread
with a slight jerk. Tighten the screw slightly.
Содержание 2013 TE 125 EU
Страница 2: ......
