HUSABERG 2013 TE 125 EU, Руководство пользователя

Страница: 62 / 129

11 SERVICE WORK ON THE CHASSIS
60
L00228-10
Main work
–
Press the chain upward at the end of the chain sliding piece and determine chain
tension
A
.
Info
The lower chain section
1
must be taut.
When the chain guard is mounted, it must be possible to pull up the chain
at least to the point where it makes contact with chain guard
B
.
Because chain wear is not always even, repeat this measurement at differ-
ent chain positions.
Chain tension 55… 58 mm (2.17… 2.28 in)
» If the chain tension does not meet specifications:
–
Adjust the chain tension. ( p. 60)
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 44)
11.38 Adjusting the chain tension
Warning
Danger of accidents Danger caused by incorrect chain tension.
–
If the chain tension is too high, the components of the secondary power train (chain, engine sprocket, rear sprocket, bear-
ings in transmission and rear wheel) are under additional load. Apart from premature wear, in extreme cases the chain can
rupture or the countershaft of the transmission can break. On the other hand, if the chain is loose, it can fall off the engine
sprocket or the rear sprocket and block the rear wheel or damage the engine. Check the chain tension and correct if neces-
sary.
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 44)
–
Check the chain tension. ( p. 59)
101846-10
Main work
–
Loosen nut
1
.
–
Loosen nuts
2
.
–
Adjust the chain tension by turning the left and right adjusting screws
3
.
Guideline
Chain tension 55… 58 mm (2.17… 2.28 in)
Turn adjusting screws
3
on the left and right so that the markings on the left
and right chain adjusters are in the same position relative to reference marks
A
.
The rear wheel is now correctly aligned.
–
Tighten nuts
2
.
–
Make sure that chain adjusters
4
are fitted correctly on adjusting screws
3
.
–
Tighten nut
1
.
Guideline
Nut, rear wheel spindle M20x1.5 80 Nm (59 lbf ft)
Info
The wide adjustment range of the chain adjusters (32 mm (1.26 in))
enables different secondary ratios with the same chain length.
Chain adjusters
4
can be turned by 180°.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 44)