HUSABERG 2013 TE 125 EU, Руководство пользователя

Страница: 81 / 129

13 WHEELS, TIRES
79
101848-11
Main work
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
x
–
Clean and grease shaft seal rings
1
and bearing surface
A
of the spacers.
Long-life grease ( p. 121)
–
Insert the spacers.
101849-10
–
Lift the rear wheel into the swingarm, position it, and insert wheel spindle
2
.
–
Put the chain on.
101849-10
–
Position chain adjuster
3
. Mount nut
4
but do not tighten it yet.
–
Make sure that chain adjusters
3
are fitted correctly on adjusting screws
5
.
–
Check the chain tension. ( p. 59)
–
Tighten nut
4
.
Guideline
Nut, rear wheel spindle M20x1.5 80 Nm (59 lbf ft)
Info
The wide adjustment range of the chain adjusters (32 mm (1.26 in))
enables different secondary ratios with the same chain length.
Chain adjusters
3
can be turned by 180°.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 44)
13.5 Checking the tire condition
Info
Only mount tires approved or recommended by HUSABERG.
Other tires could have a negative effect on handling characteristics.
The type, condition, and air pressure of the tires all have an important impact on the handling characteristics of the motorcy-
cle.
The tires mounted on the front and rear wheels must have a similar profile.
Worn tires have a negative effect on handling characteristics, especially on wet surfaces.
400602-10
–
Check the front and rear tires for cuts, run-in objects and other damage.
» If the tire exhibits cuts, run-in objects, or other damage:
–
Change the tire.
–
Check the depth of the tread.
Info
Note local national regulations concerning the minimum tread depth.
Minimum tread depth
≥
2 mm (
≥
0.08 in)