Hunter Motorcycles OUTLAW, Руководство пользователя

Страница: 22 / 29

22 | P a g e
[Servicing the Cooling System]
1. Completely check the cooling system every 1,000 km.
2. Check that there are no leaks, especially around the Water Pump and Water Tubes.
3. Check whether the Circulator is damaged or worn.
4. Press the Water Tubes by hand to see whether they have cracks and replace is necessary.
5. If you detect any leaks in the system, take your motorcycle to an Authorized Hunter Dealer.
FUSE REPLACEMENT
Remove the right guard board by loosening the hex bolt on the main seat and open the Fuse Box
(white) to replace the fuse. There are 2 spare fuses for your motorcycle. Reinstall the cover after
replacing the fuse. The specified fuses are 15 Amp.
When frequent fuse failure occurs. It usually indicates a short circuit or an overload in the
electrical system. See your Authorized Hunter Dealer for repair.
Caution
Replace only with the specified rated fuse.
Never use other conductive materials as a
substitute for a fuse. This can cause very
serious damage to the motorcycle’s
electrical system.
Turn the Ignition Switch off before
checking or replacing fuses to prevent
accidental short-circuiting. To replace the
fuse in the fuse box, remove and replace
the fuse using pliers.
See your Authorized Hunter Dealer if you
are unsure about any electrical issues.
CLEANING
Clean your motorcycle regularly to protect the surface finishes and inspect for damage, wear and
oil leakage.
Caution

High pressure water can damage certain parts of the motorcycle. Avoid spraying high
pressure water at the following areas – Ignition Switch, Handlebars, Instruments, Muffler
outlet and under the Seat.

Prevent water from flowing into the Muffler, Spark Plugs and the Battery.

After cleaning, rinse the motorcycle thoroughly with plenty of clean water.

Dry the engine thoroughly. Start the engine and let it run for several minutes.

Test the brakes before riding in traffic. Several applications may be necessary to dry the
brakes out and restore normal braking.
STORAGE GUIDE
Extended storage, such as for winter (exceeding one month) requires that you take certain steps
to reduce the effects of deterioration from non-use of the motorcycle. In addition, necessary steps
should be taken BEFORE storing the motorcycle for extended periods.
Clean and dry the motorcycle. Wax all painted surfaces.
Drain the Fuel Tank. Spray the inside of the Fuel Tank with aerosol rust-inhibiting oil.
Remove the Spark Plugs and pour in a tablespoon (15-20 ml) of clean engine oil into each
cylinder. Turn off the Engine Cut-off Switch to Off position and then press the Starter Button
several times and then reinstall the Spark Plugs.