Humminbird MEGA Live, Руководство пользователя

Страница: 65 / 75

59 Control Head Setup
8. Confirm the Baud Rate
(for devices connected to the Sensor pigtail only)
If there is an accessory, such as an autopilot, connected to the Sensor pigtail cable
wires, you will need to confirm that the devices are communicating at the same
baud rate. The baud rate details are as follows:
•
If the GPS Heading Sensor is connected to the control head, and NMEA
Output is turned on,
the control head will operate exclusively at a baud rate
of 38400. If there is an accessory attached to the Sensor’s pigtail, it also needs
to operate at 38400. See your accessory installation guide to set the baud rate
to 38400.
• If NMEA Output is turned off, then baud rates 4800, 9600, and 38400 are
available on the control head and no further action is required.
Turn On/Off NMEA Output
APEX/SOLIX
1. Press the HOME key.
2. Select Settings > Network > NMEA 0183 > NMEA 0183 Output.
3. Tap the on/off button.
HELIX
1. Main Menu: Press the MENU key twice.
2. Select the Setup tab (G3N models) or the Data Sources tab (G4N models) >
NMEA 0183 Output.
3. Press the RIGHT or LEFT Cursor keys to select On or Off. (Default = Off)
NOTE: The menu option in your Fishing System will be called NMEA 0183 Output or
NMEA Output. If the menu option is not shown under the Setup or Data sources tab,
make sure the User Mode is set to Custom (Setup tab > User Mode > Custom).
9. Set up the Network
After you have confirmed all connections, the MEGA Live Imaging transducer is
ready to use on the water. Proceed to your
MEGA Live Operations Manual to set
up the GPS source, temperature source and additional sonar sources.