Hudson 63 1936, Руководство по механическим процедурам

Страница: 37 / 333

MECHANICAL PROCEDURE MANUAL
SECTION 4
Page 15
(105) Remove both nozzle plugs (29) and gasket assem-
blies (Figure 425).
(106) Remove both nozzle retainer plugs (32) and nozzles
(31) (Figure 426). Nozzles are just pressed in and are held
by retainer plugs; use nozzle puller included in J-819-B Kit.
(107) Remove the four flange attaching screws (32) (two
shown) and lock washers to remove body flange assembly
(108) Remove body flange gasket and both idle passage
gaskets (33) (Figure 427).
Figure 426
(109) Remove both low speed jets (34) and gasket assem-
blies (Figure 427).
(110) Remove check valve passage plug (Figure 427)
gasket and strainer assembly (35) (Figure 428).
(111) Remove intake ball check plug assembly (36) and
discharge ball check assembly (37) (Figure 428).
Body Flange Assembly
(112) Remove the four throttle valve attaching screws (39)
and both throttle valves (40) (Figure 429).
Figure 427
(113) Remove throttle centering screw (41), throttle shaft
arm attaching screw (42), throttle shaft washer and throttle
shaft arm (43) (Figure 429).
(114) Now remove throttle shaft and lever assembly (44)
(Figure 429).
(115) Remove idle adjustment screws (45) and springs (46)
(Figure 429).
(116) Remove both idle port plugs (47) (Figure 429).
To Reassemble
(117) Before reassembling carburetor, clean all parts with
clean gasoline, using a small brush and a
Figure 428