Hudson 63 1936, Руководство по механическим процедурам

Страница: 256 / 333

SECTION 21
Page 8
MECHANICAL PROCEDURE MANUAL
If the latch edge of the door is high spread the upper hinge
and if low spread the lower hinge only.
If the door sets too close to the latch pillar the hinge pins
should be removed with B-170 Hinge Pin Remover and the
door removed. The body half of the hinge can then be sprung
by using a fiber block and hammer as shown in Figure 2109.
Door Bumper Adjustment
The door rubber bumpers should be adjusted so that the
rear edge of the front door should be out slightly further than
the front edge of the rear door. On 1934 through 1936 models
the rubber bumpers at the front edge of the front door should
be adjusted so that the front edge of the door sets in slightly
further than the pillar post edge. This is done to prevent wind
noise.
To adjust the bumpers loosen the screws (B) (Figure 2110),
slightly move the bumpers to the desired position and tighten
the screws.
Door Dovetail Adjustment
The door dovetail should be adjusted so that it raises the
door when it enters the female member. To adjust the posi-
tion of the dovetail, loosen the screws (A) and move the male
member to the position desired and retighten screws.
Striker Plate Adjustment
If all the above adjustments have been made properly
it will only be necessary to set the striker plate in far
enough to hold the door against the bumpers. It should
not be necessary to slam the door in order for the latch
to enter behind the striker plate.
To adjust the striker plate loosen the two screws (C),
shift the striker plate as necessary and tighten screws
securely. Caution: Do not remove screws (C) as the
tapping plate into which they enter will fall out of posi-
tion.
Seat Adjustment
All driver's seats are mounted on an adjustable mech-
anism to provide forward and rearward movement.
Figure 2111 shows the mechanism used on all sedan
seats and divided type Brougham driver's seats. By
pulling up on the handle the seat is released and allowed
to move forward.
Figure 2112-1937 Brougham Seat Mechanism—driving
position
Figure 2110—Striker Plate, Dovetails and Bumpers
Figure 2111—Sedan and Divided Seat Mechanism