Hudson 63 1936, Руководство по механическим процедурам

Страница: 272 / 333

SECTION 22
Page 14
MECHANICAL PROCEDURE MANUAL
forward (rear on right-hand drive) socket and tighten nut.
NOTE: On right-hand drive installations the long control cable
should be attached to the volume (left) control knob.
8. Insert speaker lead plug "J" into case. The plug has three
prongs, unequally spaced—be sure they are aligned with the
sockets in the case.
9. Insert pilot light in control head.
10. Attach feed wire to Battery Terminal of the ignition lock
"N" and connect to socket "M", being sure that fuse is in place
in socket.
11. Lay out antenna on floor under car with lead-in end at
front of left running board. Remove all twists and kinks. Attach
hook at lead-in to front hole in left running board, second hook
to front hole in right running board, continuing back and forth until all but the last hook has been put in place. Start at
the right front and work backward, drawing the antenna
wire tight to take up slack and permit the last hook to be
attached to the right running board.
12. Insert the lead-in through the hole in body floor
panel in line with left front door, front pillar post, lead-
ing up behind kick panel behind radio receiver and
connect to socket "L."
13. Attach one small condenser on gasoline tank gauge
unit with one unit mounting screw, attaching condenser
terminal to gauge unit terminal. (Insert "DD").
14. Attach one small condenser to upper rear cap " screw
in engine water manifold and attach condenser terminal
to terminal of water temperature gauge
Figure 2210—Installation-1936 Receiver—Model H-6