Hubner C-FLEX, Руководство пользователя

Страница: 49 / 82

49 | 82
OWNERS MANUAL | C-FLEX | D0579-B DECEMBER 2019
Combining Constant Power operation and Constant Current operation during alignment
When aligning the C-FLEX, one way to stop and start the emission is to set the constant current level to zero
and set the constant power level to the nominal output power and then use the mode button in the Cobolt
Monitor software to toggle between Constant Power operation and Constant Current operation. This will allow
the user to maintain the laser in an armed state with all temperature controls running while stopping emission
when aligning other laser lines.
Pause Emission with Commands
DANGER – Pausing the laser radiation does not make it inaccessible and will not prevent emission
in a fail safe way. Laser ON warning indicators will be illuminated as the lasers are considered
armed for operation. Treat the system accordingly and observe all safety precautions.
There is a command to temporarily stop emission without changing the current or power set points saved in the
laser memory. To stop emission use the command ‘l 0r ’ and to resume emission use the command ‘l 1 r’ . Below
is a step by step instruction on how to control emission with these commands via Cobolt Monitor. It is not
recommended to use the Pause Emission commands to turn the laser ON and OFF rapidly. See section 6 :
Controlling Emission with Modulation Mode Operation for instructions on high speed emission control.
1. Open a command window for each laser. The laser COM port will be displayed in both the laser control
sections of the Cobolt Monitor main window and in each command window. Use this information to
keep track of which command window corresponds to a certain laser.