Hubner C-FLEX, Руководство пользователя

Страница: 26 / 82

26 | 82
OWNERS MANUAL | C-FLEX | D0579-B DECEMBER 2019
2. Place the remote interlock jumper, a 2 pin molex jumper with a green wire, into the remote interlock
socket or, if applicable, connect the external interlock.
3. Connect the System Data cable’s USB-B connector to the socket labeled ‘USB 2.0’.
4. Connect the System Data cable’s USB -A connector to the PC being used to control the C-FLEX.
5. Connect the 15 V / 7 A power supply to the Kycon power socket on the C-FLEX.
6. To start the lasers, turn the key to the ON position. If it is already in the ON position, turn it to OFF and
then ON again.
Once the key is turned to the ON position the lasers will automatically start up, Wait at least 3 minutes for the
lasers to stabilize. See section 5 for detailed discussion of the emission control options in continuous wave
operation.
Each Cobolt laser will go through the auto start sequence:
Waiting for Temp Laser emission is not enabled until all temperatures have
reached their set point and the TECs are stabilized.
Waiting for Key Toggle the key to proceed, if the key is already in the ON
position, turn OFF and ON again.
Warm up A low current is provided to warm the laser before setting
full power
Completed The device is emitting or armed for emission.
7. Verify that all Status LEDs are green, including those on the Laser Controllers.