Hubner C-FLEX, Руководство пользователя

Страница: 77 / 82

77 | 82
OWNERS MANUAL | C-FLEX | D0579-B DECEMBER 2019
Beam Path Alignment – Reference Laser Re-Alignment
This section describes the realignment the reference laser. This should only be necessary when replacing a laser
or if the beam path has for some other reason become drastically misaligned.
NOTICE – This is a drastic re-alignment and should only be performed if absolutely necessary
– OR – when integrating a new laser head.
DANGER – Laser Radiation is accessible when the safety interlock is defeated. Avoid skin and eye
exposure to direct or scattered radiation. Close the shutter before powering up the system.
WARNING - Alignment and maintenance of the lasers inside the C-FLEX should only be performed by
trained personnel with appropriate laser safety equipment.
1. Begin with laser farthest from the aperture, the position number may vary depending on configuration.
Thi s will be considered the ‘reference laser’.
2. Place a fast optical power meter 10 cm from the aperture mounted pin hole and secure it in place.
Moving the detector can affect the measurement.
3. Resume the emission of the laser line in the position farthest from the aperture (the red laser line shown
a bove, in position 6). This is considered the ‘reference laser’.
4. Check that the beam is hitting the steering mirror in the center horizontally, if the beam is far from the
center of the mirror loosen the laser head mounting screws and push or twist the laser head gently until
the beam hits the center of the steering mirror.