HP ProLiant ML110 G7, Руководство пользователя

Страница: 47 / 113

Hardware options installation 47
UDIMM maximum memory configurations
The server supports a maximum of 16 GB, using 1-GB, 2-GB, and 4-GB single- or dual-rank UDIMMs.
General DIMM slot population guidelines
•
The server has four memory slots.
•
The server supports two channels with two DIMM slots per channel.
o
Memory channel A consists of the two DIMM slots that are closest to the processor.
o
Memory channel B consists of the two DIMM slots that are farthest from the processor.
•
White DIMM slot indicates the first slot of a channel (2-A, 4-B).
•
Memory speed support depends on the type of processor installed. See the technical specification of the
installed processor for more information.
•
The server supports dual-rank, 1333 MT/s ECC DIMMs.
•
The server supports up to 16-GB (4x4 GB) DIMMs.
•
The server does not support:
o
LV-DIMMs
o
RDIMMs
o
Non-ECC DIMMs
•
When installing DIMMs:
o
If the processor is not installed, then do not install DIMMs
o
Populate the DIMM slots in the sequence: 2-A, 4-B, 1-C, 3-D
o
The DIMM slot farthest from the processor (either CHA or CHB) must be populated first
o
Populate DIMM slots from heaviest load (double-rank) to lightest load (single-rank)
o
Use HP-qualified DIMMs
NOTE: The server does not support Elpida 1G/2G/4G UDIMM memory.
Installing a DIMM
1.
Power down the server (on page 19 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Unlock the tower bezel (" Unlock and open the tower bezel " on page 20 ).
4.
Remove the access panel (on page 21 ).
5.
Open the DIMM slot latches.