HP ProCurve 4104GL, Руководство по управлению и настройке

Страница: 321 / 504

13-13
802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
Configuring Rapid Reconfiguration Spanning Tree (RSTP)
N o t e
Executing the
spanning-tree
command alone enables spanning tree. Executing
the command with one or more of the whole-switch RSTP parameters shown
in the table on the previous page, or with any of the per-port RSTP parameters
shown in the table on page 14, does not enable spanning tree. It only configures
the spanning tree parameters, regardless of whether spanning tree is actually
running (enabled) on the switch.
Using this facility, you can completely configure spanning tree the way you
want and then enable it. This method minimizes the impact on the network
operation.
Multiple parameters can be included on the same command line. For example,
to configure a maximum-age of 30 seconds and a hello-time of 3 seconds, you
would issue the following command:
HPswitch (config)# span max 30 hello 3
Syntax: Abbreviations:
spanning-tree
protocol-version <rstp | stp>
force-version <rstp-operation | stp-compatible>
priority <0 - 15>
maximum-age <6 - 40 seconds>
hello-time <1- 10 seconds>
forward-delay <4 - 30 seconds>
span
prot <rstp | stp>
forc <rstp | stp>
pri <0 - 15>
max <6 - 40>
hello <1 - 10>
forw <4 - 30>
Defaults: see the table on the previous page.