Webcam/microphone module
NOTE:
This section applies only to computer models equipped with BrightView display assemblies.
NOTE:
If it has been determined that the webcam/microphone module is the component that must be
replaced to complete the computer repair, the display assembly does not have to be removed. Follow
the procedures in this section to replace the webcam/microphone module. For information on replacing
the display assembly and other display assembly internal components, see
Display assembly
on page 73
.
Description
Spare part number
Webcam/microphone module
480446-001
Before removing the webcam/microphone module, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 51
).
Remove the webcam/microphone module:
1.
Turn the computer display-side up, with the front toward you.
2.
Open the computer as far as possible.
3.
Flex the inside edges of the top edge
(1)
and the left and right upper corners
(2)
of the display bezel
until the bezel disengages from the display enclosure.
4.
Release the display bezel top edge
(3)
from the display enclosure.
Component replacement procedures
53
Содержание Pavilion dv7-1100 - Entertainment Notebook PC
