Table 3-3
Telnet Commands and Parameters (continued)
roam-threshold
Specify the wireless signal strength level where the print server seeks an access point
that provides a stronger signal strength. Select from the following levels:
2
(Default): Sets the threshold to a weak signal.
1
: Sets the threshold to a very weak signal.
0
: Sets the threshold to where there is no detected signal.
When the print server is associated with a particular access point, it remains with that
access point until the specified threshold level is reached. Setting the threshold level to
0 or 1 can prevent or limit the print server from roaming.
802.11 Wireless Diagnostics
Current SSID
(Read-only parameter) The network name (SSID) to which the wireless print server is
connected.
Current Channel
(Read-only parameter) The channel that the wireless print server is currently using.
Signal Strength
(Read-only parameter) Strength of the radio signal received by the print server.
<blank>
: No radio signal detected while the print server is scanning.
No Signal
: No radio signal detected on any channel.
Poor/Marginal/Good/Excellent
: Detected signal strength level.
Access Point Mac
(Read-only parameter) The media access control (MAC) address of the access point
used for Infrastructure mode communications, as in the following example:
00:a0:f8:38:7a:f7
In this example, the access point with MAC address 00a0f8387af7 is used for
communicating on the network.
TCP/IP Main
llmnr
Link local multicast name resolution (LLMNR).
0
: Disable.
1
(defualt): Enable.
host-name
Name of the network device. Enter up to 32 alphanumeric characters.
For example,
host-name printer1
assigns the name
printer1
to the device. The
default host name is NPIxxxxxx, where xxxxxx are the last six digits of the LAN
hardware (MAC) address.
ip-config
Print server configuration method. Use the following values:
manual
: Wait for IP parameters using manual tools, such as Telnet, the HP Embedded
Web Server, the control panel, or installation/management software. Status is
User
Specified
.
bootp
: Send BOOTP requests on the network for dynamic IP configuration.
dhcp
: Send DHCP requests on the network for dynamic IP configuration.
auto_ip
: Automatically configure with a unique link-local address 169.254.x.x.
46
Chapter 3 TCP/IP configuration
ENWW
Содержание Jetdirect 640n
