2.
Remove the memory carrier assembly. See
“Removing and Replacing the Memory Carrier
Assembly” (page 56)
.
NOTE:
To avoid damage to the handles, HP recommends rotating the handles inward and
snapping them into place when servicing the system DIMMs or any time the carrier is out of
the chassis. Before replacing the memory carrier, press the button to release the extraction
handles. Use the handles to replace the memory carrier into the chassis.
3.
Complete the following memory installation prerequisite tasks before installing the memory:
a.
Determine the DIMM load order for the 48-DIMM memory carrier. For more information,
see
“Memory Load Order” (page 61)
.
b.
Use
Figure 27
to determine the DIMM slots to populate.
c.
Read, understand, and follow the general guidelines to install memory in the server. See
“Memory Loading Rules and Guidelines” (page 62)
.
4.
Lay the memory carrier assembly on side 0 or side 1 so that the memory carrier side that
contains the DIMM slots that you will install DIMMs into faces upward (
Figure 25
).
5.
Remove the memory carrier assembly side cover.
a.
Press the release tabs (
Figure 25
) on both sides of the extraction handle release button
until the side cover releases from the top center of the assembly.
b.
Rotate the side cover slightly to free the tabs from the retaining slots at the base of the
assembly (
Figure 26
).
c.
Lift the side cover off the assembly.
64
Installing the System
