HP Hyper Converged 380, Руководство по установке

Страница: 46 / 125

Completing the initial HC380 Management UI configuration 46
Completing the initial HC380 Management UI
configuration
Configuring the settings
Process overview:
1.
Performing the initial HC380 Management UI setup (on page 46 )
2.
Configuring LDAP or Active Directory (on page 47 )
3.
Creating datastores
Performing the initial HC380 Management UI setup
Most of the setup values are populated during the configuration using the OneView InstantOn tool, and
you can use the Settings area in HC380 Management UI to verify or update the values.
1.
Using Mozilla Firefox, log into HC380 Management UI using Administrator and the new password
that you set in the step "Installing the HC380 Management UI."
A new screen appears to notify you that your HC380 is ready to be shaped.
2.
Click Setup .
The Setup screen appears.
3.
Click the pencil icon for the Identity section.
4.
Provide the Embedded OneView IPv4 address for the OneView configuration.
This address was collected in the preinstallation worksheets (on page
14 ).
5.
Verify and update, as needed, the values in the other fields, then click OK .
6.
Click the pencil icon for the vCenter section.
7.
Type the vCenter IP address and click
Connect
.
This address was configured by OneView InstantOn and shown on the Next Steps screen.
8.
Accept Trust and click OK .
9.
To connect the HC380 to an LDAP server or Active Directory server, click the pencil icon for the
Directory section and see "Configuring LDAP or Active Directory (on page 47 )."
10.
Click Setup in the Nodes section.
11.
Specify the iLO credentials and iLO passwords for each hypervisor host, as shown in the
pre-installation worksheet. Ensure that the iLO matches the correct host.
If your environment uses common credentials for iLO, provide the common user name and
password and enable each host to use the common credentials.
12.
Click OK .
13.
Click Submit .