Expanding the system 71
2.
On the Dynamic Discovery tab
a.
Select Add…
b.
Provide the iSCSI Server IP. You can obtain this IP in two ways.
—
From the other nodes configured on vCenter
—
From the CMC, navigate to the VSA cluster then go to the iSCSI tab. The iSCSI Server IP is
the value of the Virtual IP.
c.
Click CHAP… and verify that both Inherit from Parent checkboxes are selected.
3.
The Static Discovery tab should be automatically updated. If not, perform these steps:
a.
Select Add…
b.
Provide the iSCSI Server IP similar to the Dynamic Discovery.
c.
Provide on the iSCSI Target Name the IQN you obtained earlier on step 13 above of the CMC
setup section.
d.
Click CHAP… and verify that both Inherit from Parent checkboxes are selected.
e.
After closing the Properties dialog, perform a Rescan.
The iSCSI device is displayed on the Details dialog.
f.
Go to the storage and verify that the datastore also shows up on the newly added node.
Configure the VDS of vCenter
1.
Use the following steps to configure the new Compute node to the virtual distributed switches:
a.
Using the vSphere Client, go to Inventory > Networking.
b.
Right click on CS9_Compute_DVS and click Add Host…
i.
Select the new node.
ii.
Select physical adapters vmnic6 and vmnic7.
iii.
Set the destination port group of vmk3 to dvESXcomp.
iv.
Click Next on the Virtual Machine Networking.
v.
Click Finish.
c.
Right click on Comp-CloudData-Trunk and click Add Host…
i.
Select the new node.
ii.
Select the physical adapters vmnic8 and vmnic9.
iii.
Click Next on Network Connectivity.
iv.
Click Next on Virtual Machine Networking.
v.
Click Finish.
2.
Use the following steps to configure the new Management node to the virtual distributed switches:
a.
Using the vSphere Client, go to Inventory > Networking.
b.
Right click on CS9_Mgmt_DVS and click Add Host…
i.
Select the new node.
ii.
Select physical adapters vmnic6 and vmnic7.
iii.
Set the destination port group of vmk3 to dvESXmgmt.
iv.
Click Next on the Virtual Machine Networking.
v.
Click Finish.
c.
Right hpcs-dataXXXXXX distributed vswitch and click Add Host…
i.
Select the new node.
ii.
Select the physical adapters vmnic8 and vmnic9.
