HP DESIGNJET 3D, Руководство по обслуживанию

Страница: 65 / 458

-49
7. Place the carrier on a flat stable surface.
8. Open the carrier.
9. Rotate the spool to rewind the material, leaving 2 inches (50mm)
remaining at the material guide. See Figure 29.
Figure 29: Rewinding the material spool
10. Using a cutters, cut the excess 2 inches (50mm) of material from the
material guide, leaving a blunt end.
11. Replace the material spool.
12. Close and latch the carrier.
13. Once the material carriers have been replaced press
Load...
14. You can select which carriers you want to load to the head by selecting
Next Model
or
Next Support
. When done selecting press
Load Selected
.
15. The printer will now load the selected material bays and prepare the
other bays for automatic loading. After they are done loading and pre-
paring, press
Done...
the display will show
Wait for Part
or
Ready to
Build
.
Material bay LEDs
The table below will show the status indicated by the LEDs.
CAUTION: Do not push the material through the material guide
back into the carrier, doing so can cause material to break or
become tangled.
On Material currently loaded to the head
Off No carrier present
Carrier present and ready to be loaded
Blinking Carrier needs replacement (is empty or has an
error)