HP DESIGNJET 3D, Руководство по обслуживанию

Страница: 110 / 458

-94
14,41 Abort : Motion
command while door
open.
14,42 Abort : Load cartridge
while door open.
14,43 Abort : Modeling
command while door
open
14,44 Abort : Select head
command while door
open.
14,47 Abort : Tip wipe
command while door
open.
1. Check to see if door latch is activating using
LED's.
2. Check J504 pins 8 and 20 on the I/O card
for loose contacts or bent pins.
3. Look at LCD display, should show "Door
Open" when machine is idle and door is
open.
4. Using LED's check to see "Door Open"
toggles when switch is activated. If not,
check door switch and/or Mid-Unit
Harness.
5. Wiggle the door, make sure the sensor
reads the magnet with movement to the
door.
6. Check that the door magnet is present.
14,45 Report: Unable to write
to model material guide
tube.
14,46 Report: Unable to write
to support material
guide tube.
1. Try a different material spool.
2. Clean contacts on carrier and material bay
with an eraser.
3. Replace carrier.
4. Replace material bay.
14,48 Abort : Vertex command
error.
1. If this message is displayed on LCD ONLY,
possible memory problem, replace SBC. If
this message is not displayed on the LCD,
(seen in cfg file), RAM is NOT the root
cause.
2. If the frequency of the error is greater than
once every three months, replace the
controller board.
14,49 Internal : PCode Error,
Bad Curve.
This error will not be displayed. Software
development use only.
14,50 Internal : PCode Error,
DY within curve.
This error will not be displayed. Software
development use only.
14,51 Abort : Model material
not loaded.
14,52 Abort : Support material
not loaded.
14,53 Abort : Model head
motor not ready.
14,54 Abort : Support head
motor not ready.
1. Reload material.
Note:
System is not recognizing that material is
loaded.
Code Description Corrective Actions