HP DESIGNJET 3D, Руководство по обслуживанию

Страница: 356 / 458

-340
4. Press the
Next...
button.
5. Press the
Next...
button.
6. Press the
ZT2T
(Z tip to tip) button.
7. Enter the calibration value by pressing the
Increment
,
Decrement
and
Next Digit
buttons.
8. When finished, press
Done...
9. Press the
Next...
button until you reach the last page.
10. Press the
Done...
button.
11. Press the
Save and reboot
button.
12. The printer will reboot and return to idle.
13. Perform automatic Z calibration. See
“Z Calibration” on page 338.
XY Tip Calibration
1. Press
Maintenance.
2. Press
Machine.
3. Press
Tip.
4. Press
Calibrate XY.
5. Press
Start Part.
The printer will automatically build an XY Tip Calibra-
tion part. (Build time is approximately 10 minutes).
6. When the XY Tip Calibration part is complete the printer will display
Remove Part and Select XY Adjustment - X:0, Y:0
7. Remove the XY Tip Calibration part from the printer.
8. Inspect the part and calibrate the X and Y axes as follows (See
Figure
320 ).
A. Use the magnifier from the Startup Kit to view the support
road.
B. Identify the location on the +X or –X side of the part where
the support road is best centered within the model
boundaries.
C. Read the number closest to this location. This is the
required X Tip Offset adjustment, in mils. If the number is
on the -X side, a negative offset is required.
D. Select
Increment
or
Decrement
to input the X offset
adjustment - the value will change in the upper display
window (by default, the printer will be ready to accept the
X value).
E. Once you have entered the X offset value,
Select Y
and
repeat the procedure for Y Offset value.
9. Select
Done
after you have input the X and Y tip offsets. The printer will
return to
Maintenance
.
10. Repeat steps 1-9 to verify proper calibration.
NOTE: The value for ZT2T must be between -0.0500” and
0.0500”.